Previous topic

Next topic

Parent topic

Locate in Contents

Upgrading to Check Point R80 Support

Check Point R80 devices use CPMI and REST API protocols to integrate with SecureTrack. After you upgrade your Check Point devices, some SecureTrack features stop working until you upgrade the device in SecureTrack to R80 support.

During the upgrade, you connect to the host Check Point MDS for the CMA. SecureTrack shows a list of all CMAs on the MDS and on any other MDSs that are configured for High Availability. All CMAs that are shown are upgraded to R80 support at the same time.

SecureTrack gives the same feature support for R80 devices as for versions lower than R80, except for the Baseline Settings Compliance Report. If you have a Baseline Settings Compliance Report configured, you must delete it before you can upgrade to R80 support.

Prerequisites

Before you upgrade to R80 support, you must have:

To ensure that you the SecureTrack server has been granted access to the Check Point API server, follow the resolution steps in Troubleshooting: Check Point R80 - "CheckPoint API client error".

Procedure

To upgrade a CMA to R80 support:

  1. Go to: Settings > Monitoring
  2. Select a Check Point CMA device from the list of Monitored Devices.
  3. Click Upgrade to R80.

  4. Enter:

  5. Click Continue.
  6. Review the list of devices to upgrade to R80 support.
  7. Click Upgrade.

    The upgrade process may take a few minutes to complete. Do not leave the page of the upgrade process until the upgrade process is complete.

  8. When the upgrade process is complete, click Done.

In This Section

Troubleshooting: Check Point R80 - "CheckPoint API client error"

Managing Devices in Domains